新浪微博腾讯微博|||Online MessageWelcome to ZhongDe Bearing Manufacture Co., Ltd

Keyword: 20072  230 1060  22207  22205  请输入关键词搜索  22206

current position:Home > News > Industry news > Stop check of rolling bearings

Stop check of rolling bearings

from:未知editor:adminhot:time:2016-10-08 17:14【big middle small
Regular inspection of the bearing seal is to maintain the bearing in the best condition is very important work.The most advantageous inspection time is arranged in regular outage inspection period.
The importance of clean bearing:
It is important to keep the bearing and lubrication clean.
Need before checking surface cleaning machine, and then remove the perimeter of the bearing parts.Oil seal is very fragile parts, so need to carefully remove, not excessive force, and then carefully check oil seal and its surrounding parts, if has presented the adverse symptoms, be sure to replace the bad oil seal will cause the damage of the bearing and the cause of equipment downtime.
Check the lubricant
Of lubricant on friction between two fingers, if the presence of pollutants, can feel out, or in the back with a thin layer of lubricant, then seal of inspection.
Replace the lubricant
Oil lubricated bearings after xie used engine oil, possible, impregnated with fresh oil and let the machine in low speed rotation for a few minutes.As far as possible make the oil collecting residual pollutants, then spilled oil in addition to these, the oil before use it's best to filter it.
Grease lubricated bearings should avoid when replacing grease with cotton material come into contact with any part of the bearing, because these residues fiber may wedged in between the scroll and damage, especially the application of small bearing more need to pay attention to this problem.
Covering exposed bearing
Check the bearing, don't let bearing exposure to pollutants or moisture environment.If the job is interrupted, should with oil or similar materials cover paper plastic film machine.
If don't have to remove and may perform inspection of cleaning bearing without masking, want to touch with brush coating on petroleum solvent (white spirit) cleaning, then dry with a lint-free cloth or use compressed air to blow dry (be careful not to let the bearing component starting rotation).
Do not clean the encrypted block or dust bearing;You just wipe the outer surface.
If the bearing is need to replace damaged situation.In regular maintenance downtime period change bearing than due to bearing damage caused by the sudden shutdown loss much more economical.

Recommended products